Installing­battery­in­the­re- Mote­control - Grundig SC 990 iP Manual

CONNECTION­AND­PREPARATION
Installing­battery­in­the­re-
mote­control
1
Open the battery compartment by pushing the
small latch to the left and at the same time slid-
ing the battery tray out.
2 Insert one CR2032 battery into the battery
tray with the correct polarity as shown on the
battery tray.
3
Slide the battery tray into the battery compart-
ment until it clicks into its place.
1
1
2
1
3
Installing­back-up­battery­in­
the­device
During mains operation, the back-up battery en-
sures that the stored settings are not lost in the
case of a power failure or when the device is
briefly disconnected from the mains.
1­Open the back-up battery compartment on
the left side of the device by pushing the small
latch upwards and at the same time sliding the
battery tray out.
2 Insert one CR2032 battery into the battery
tray with the correct polarity as shown on the
battery tray.
3
Slide the battery tray into the battery compart-
ment until it clicks into its place.
Notes:
Do not expose the batteries to extreme heat,
7
caused for example by direct sunlight, heat-
ers or fire.
Remove the batteries when they are flat or
7
when you know that the device will not be
used for a long period of time.
Environmental­note:
Batteries, including those which do not con-
7
tain heavy metal, should not be disposed
of with household waste. Always dispose
of used batteries in accordance with local
environmental regulations.
­---------------------------------------
9­
ENGLISH