Page 2
________________________________________________________________ Sicherheit/Informationen DEUTSCH Auf einen Blick Stromversorgung Einstellungen Betrieb Service Safety/information ENGLISH Overview Power supply Settings Operation Service Sécurité/Informations FRANÇAIS Vue d’ensemble Alimentation électrique Réglages Fonctionnement Service Sicurezza/Informazioni ITALIANO In breve Alimentazione elettrica Impostazioni Funzionamento Service Segurança/Informações PORTUGUÊS Vista geral Alimentação de corrente Regulações Funcionamento...
Page 3
SAFETY/INFORMATION _____________________ ENGLISH Safety This device is designed for the playback of audio signals. Any other use is expressly prohibited. Protect the device from moisture (water drops or splashes). Do not place any vessels such as vases on the device. These may be knocked over and spill fluid on the electrical components, thus presenting a safety risk.
Page 4
OVERVIEW ____________________________________________ Controls on the top Interrupts the alarm function. SNOOZE Displays the seconds. • • »ALARM « sliding switch is in the » « TIME position: press and hold down to set the time. • »ALARM « sliding switch is in the ”Natural Sound”...
Page 5
OVERVIEW _________________________________________________ Press briefly to switch on the radio or to display the SLEEP current sleep timer setting. Hold down to shorten the remaining time until the unit switches off. Switches the radio on from standby mode. RADIO ON Switches the radio to standby mode. RADIO/ALARM Selects the alarm tone ”water”, ”frog”, ”rooster”...
OVERVIEW _________________________________________________ Activates alarm times 1 and 2, or 1+2. Sliding ALARM 1 1+2 2 switch on left side of device. For tuning to radio stations (on the right side of the TUNING device). Adjusts the volume (on the right side of the device). VOLUME Controls on the back Power cord.
Page 7
OVERVIEW _________________________________________________ The display ALARM 1 • • ALARM 2 ALARM 1 G LED. Indicates that the alarm setting is activated with alarm time 1. ALARM 2 G LED. Indicates that the alarm setting is activated with alarm time 2. Shows the time, the alarm time and the switch-off time.
POWER SUPPLY ___________________________________ Mains operation Note: Check that the mains voltage on the type plate (on the bottom of the device) corresponds to your local mains supply. If this is not the case, contact your specialist dealer. Plug the mains cable into the socket (230 V~, 50 Hz). Note: The only way to disconnect the device from the mains supply is to pull out the plug.
POWER SUPPLY __________________________________________ Additional information for units sold in the UK. Units sold in the UK are suitable for operation from a 240V ac, 50Hz mains supply. The range of multi-system receivers is built to work in most European coun- tries.
Page 10
“E”, earth symbol “ ”, coloured green, or green & yel- low. Replacement mains lead sets can be obtained from your local dealer, or by contacting Grundig Consumer Relations (01788 570088) Moulded 3-pin lead set, suitable for UK use: Ref: Leadset UK 8290-991-224...
SETTINGS ______________________________________________ Setting the clock When you switch on the device for the first time, the time flashes in the dis- play to indicate that you must set the clock. The same applies if the device has been disconnected from the mains and no back-up battery is inserted. Switch the alarm function switch to »G«.
Page 12
OPERATION __________________________________________ Switching on and off Press »RADIO ON« to switch on the device. Switch off the device by pressing »RADIO/ALARM OFF«. Radio operation For the best FM (VHF) reception, it is sufficient to direct the wire antenna accordingly. Make sure that the wire antenna is not wedged in by the cover of the battery compartment.
Page 13
OPERATION _______________________________________________ Displaying the alarm times Note: Depending on the setting – »ALARM 1« or »ALARM 2« – either alarm time 1 or alarm time 2 is displayed. Press and hold down »ALARM«. – Display: the last alarm time set. Note: If the »ALARM 1 1+2...
Page 14
OPERATION _______________________________________________ Press »NATURAL SOUND « repeatedly to choose from the alarm tones ”water”, ”frog”, ”rooster” and ”wind”. – During selection, the symbols light up one by one and the natural sound is played back. – The device switches on at the set alarm times with the natural sound selected (alarm duration 59 minutes).
OPERATION _______________________________________________ Timer mode The device possesses a sleep timer, which switches it off in radio mode at a preset time. It is possible to set the switch-off time to up to 59 minutes. Setting the sleep timer Press »SLEEP« to switch on the device. –...
______________________________ GRUNDIG Deutschland Ihre regionale Kundendienst-Stelle in Deutschland erreichen Sie unter: Telefon 0180/5 23 18 52* • Telefax 0180/5 23 18 46* *gebührenpflichtig GRUNDIG BELUX N.V. GRUNDIG SCHWEIZ AG GRUNDIG OY Deltapark, Weihoek 3, Unit 3G Steinacker Straße 28 Luoteisrinne 5...
Page 17
Grundig AG • Beuthener Str. 41 • D-90471 Nürnberg • http://www.grundig.com 72011 402 5000...
Need help?
Do you have a question about the Sonoclock 52 and is the answer not in the manual?
Questions and answers