Power Supply; Mains Operation; Inserting The Back-Up Battery - Grundig Sonoclock 590 Manual

POWER SUPPLY

Mains operation

Check that the mains voltage on the type plate (on the bottom of the device)
corresponds to your local mains supply. If this is not the case, contact your
specialist dealer.
1
Plug the mains cable into the socket (230V ~ , 50 Hz Sonoclock 590,
230V ~ , 50/60 Hz Sonoclock 590 Q).
Caution:
The device is connected to the mains with the power plug. To fully
disconnect the device from the mains, pull out the plug.
The mains plug is used to disconnect the device. It shall remain readily
operable and should not be obstructed during intended use.

Inserting the back-up battery

During mains operation, the back-up battery ensures that stored settings
are not lost in the case of a power failure or when the device is briefly
disconnected from the mains.
1 Open the battery compartment lid by pressing on the arrow and pushing
down the lid.
2
When inserting the battery (9 V, 6LF 22), observe the polarity marked on
the base of the battery compartment.
3
Close the battery compartment.
Note
:
Remove the back-up battery when it is flat or when you know that the
device will not be used for a long period of time.
Batteries, including those which do not contain heavy metal, should not
be disposed of with household waste. Always dispose of used batteries
in accordance with local environmental regulations.
18 ENGLISH
________________________________