Clean Button - Shark MATRIX PLUS UR2360S Owner's Manual

IMPORTANT: The Shark Matrix™ Plus has a pre-installed rechargeable battery. Charge the battery completely
before first use. It may take up to 6 hours to fully charge.
To turn on power, place the robot on the Self-
Empty Base. When the robot is correctly placed,
the base indicator light will illuminate blue and the
robot will beep. If the base indicator light does not
turn blue, unplug the cord from the wall outlet,
then plug it back in. If the robot has no charge
remaining or it can't return to the base, manually
place it on the base.
NOTE: When manually placing the robot on the Self-Empty Base, make sure the Charging Contacts on the bottom of the
robot are touching the ones on the base.
NOTE: When picking up the robot, be careful not to place fingers between the bumper and the back of the robot.
s h a r kc l e a n . c o m
CHARGING
When the cleaning cycle is complete, or if the battery
is running low, the robot will search for the Self-
Empty Base. If the robot doesn't return to the base,
its charge may have run out.
DOCK AND CLEAN BUTTONS

CLEAN BUTTON

If the robot is on the base,
press the CLEAN button for
a whole-home clean. Press
again to pause the cleaning
session.
For a Matrix Spot Clean of
a specific 5-foot-by-5-foot
area, place the robot in the
spot to be cleaned, then
press and hold the CLEAN
button for 5 to 7 seconds.
DOCK BUTTON
To turn on/off your robot,
press the DOCK button for
5-7 seconds.
Press the DOCK button to
allow the robot to go back to
the Self-Empty Base.
To reboot the robot, remove
the robot from the base and
press and hold the DOCK
button for 14 seconds. To
turn back on, return the robot
to the base.
s h a r kc l e a n . c o m