This manual will guide you through the assembly process. If at any time you are having trouble with the assembly or use of this product, please contact us at our XMARK Fitness help line. We have trained service technicians on site to take care of you, our valued customer.
SAFETY PRECAUTIONS • This unit should only be used on a level surface and is intended for indoor use only. XMARK Fitness recommends an equipment mat be placed under the unit to protect the floor or carpet and for easier cleaning.
Assembly NOTE: Hand tighten bolts and locknuts until machine is fully assembled. Lock nuts may require additional force to tighten completely. Attach the Upright (1) to the Base (13) with an M10 x 70mm Bolt (21) and an M10 Locknut (22). Attach the Lower Support (7) to the Upright (1) with one Plate (8), two M10 x 70mm Bolts (21) and two M10 Locknuts (22).
Page 6
Bace (4) with two M8 Washers (18) and two M8 x 70mm Bolts (17). Make sure that all parts are properly tightened before you use the Vertical Knee Raise Dip Station ! Congratulations! You have completed assembly of your XM-4437.1!
Parts List Parts List Key No. Description Qty. Upright Extend Arm Upper Support Bar Upper Upright Brace Crossbar Handle Tube Lower Support Plate Arm Pad Backrest Plastic Handle Grip Foam Grip Base Inner Cap M10 x 15mm Bolt M10 Washer M8 x 70mm Bolt M8 Washer M10 x 20mm Bolt...