DEMAG Dedrive Pro ACS880- Series Quick Start Up Manual page 8

8 Quick start-up guide for ACS880 drives with primary control program
Highlight the correct setting on the list and
press
Press
99 Motor data, and set parameter 99.03 Motor type.
EN
Set parameter 99.04 Motor ctrl mode.
DE
DTC = Direct torque control; Scalar
DTC is suitable for most cases. Scalar mode is recommended if
ES
• the nominal current of the motor is less than 1/6 of the nominal current of the drive,
• the drive is used for test purposes with no motor connected, or
FI
• the drive controls multiple motors and the number of motors connected is variable.
Refer to the motor nameplate for the following parameter settings. Whenever possible, enter
FR
the values exactly as shown on the motor nameplate.
Example of a nameplate of a motor:
IT
NL
RU
SV
99.06 Motor nominal current
The allowable range is
• in DTC mode: 1/6 × I
• in Scalar mode: 0 ... 2 × I
Note: With numerical parameter values:
• Use and
• Use and
• Press
Make the following parameter settings in the same manner.
(Save).
(Back) to display the list of parameter groups again. Select parameter group
... 2 × I
Hd Hd
Hd
to change the value of a digit.
to move the cursor left and right.
(Save) to enter the value.
Local
95 HW configuration
95.01 Supply voltage
95.02 Adaptive voltage limits
95.04 Control board supply
Back
of the drive
0.0 rpm
380...415 V
Disable
Internal 24V
12:36 Edit