Table of Contents
Advertisement
Drive Stay Assembly Installation
Note: Depending on the manufacturer and style of your
tractor, the drive stay assembly mounting procedure may
vary slightly from the instructions listed below.
Cut the zip tie that secures the mount arm to the trailer.
Refer to Figure A.
Figure A
Mount Arm
Rotate the E-Drive towards the deck opening of the
tractor as shown in Figure B. (See Drive Stay
Adjustments, pg. 21 through 24).
Figure B
Rotate
Towards
Deck
Opening
Attach the ball clevis P#(B0132) to the rear left of the
tractor. There should be an existing hole in the tractor
frame for this ball clevis to mount to. Secure the ball
clevis using (1) 3/8"-16 x 1" hex bolt P#(K1191) and (1)
3/8" lock washer P#(K0048).
NOTE: If there is not an existing hole, position the ball
clevis as shown in Figure C, then mark the position. Drill
a hole in the tractor frame using a 3/8" drill bit.
Figure C
Attach the ball clevis clamp assembly P#(A0336) to the
ball clevis using (1) 5/16"-18 x 2" hex bolt P#(K1159) and
(1) 5/16"-18 locknut P#(K1180). Thread the adjusting rod
P#(B4311) into the ball clevis clamp assembly as shown
in Figure D. Insert the adjusting rod into the mounting
hole on the engine mount arm. Secure the adjusting rod
with (1) hair pin clip P#(K0099) and (1) 1/2" flat washer
P#(K0055). Refer to Figure D and E for reference.
Cut Zip
Tie
Ball
Clevis
Rear Frame
Of Tractor
Ball Clevis
Figure D
Ball Clevis
Clamp Assy
Figure E
Hex
Bolt
Nyloc
Nut
Ball
Clevis
Clamp
Adjusting
Rod
Adjusting
Rod
Hair Pin
Clip
and Washer
Advertisement
Table of Contents
