Peco 5920E Operator's Manual page 26

If necessary, cut out the traced underside of the plastic
boot to allow for blade clearance. Refer to Figure F.
Figure F
Cut Along
Traced Outline
Position the boot over the deck opening and check for
any gaps in the fit. Adjust the cut as needed. Make sure
there are no gaps between the plastic boot and the
mower deck. This will help prevent grass blowout.
Fasten the deck bracket P#(B2306) to the slide plate
P#(B2307) using (2) 1/4"-20 x 5/8" carriage bolts
P#(K1010) and (2) 1/4"-20 nylon flange locknuts
P#(K2014). Refer to Figure G.
Figure G
Deck Bracket
Place the plastic boot and deck bracket (with slide plate
attached) firmly against the mower deck as shown in
Figure H. Make sure there are no gaps between the
plastic boot and the mower deck.
Trace the (2) holes from the deck bracket onto the
mower deck.
Figure H
Center the upper clamp plate P#(B2308) over the slide
plate and trace the (2) holes onto the plastic boot. Refer
to Figure I.
Drill the (2) holes traced onto the plastic boot with 1/4"
drill bit as shown in Figure J.
Slide Plate
Drill the (2) traced holes in the mower deck using 1/4"
drill bit as shown in Figure K.
Trace (2) Holes
Onto Mower Deck
Figure I
Figure J
Figure K
Mower Deck With 1/4" Bit
Trace (2) Holes
Onto The Plastic Boot
Upper Clamp
Plate
Drill (2) Holes
With 1/4" Bit
Drill (2) Holes Into