Table of Contents
Advertisement
Insert (2) 1/4"-20 x 1" carriage bolts P#(K1025) into the
lower clamp plate P#(B2039). Insert the lower clamp
plate through the cutout in the plastic boot. Push the
carriage bolts in the lower clamp plate up through the
holes drilled in the plastic boot. Refer to Figure L.
Figure L
Insert the upper clamp plate P#(B2308) onto the (2)
carriage bolts as shown in Figure M. Secure the upper
clamp plate using (2) 1/4"-20 wing nuts P#(K1129).
Figure M
(2) Wing Nuts
Slightly loosen the (2) wings nuts on the plastic boot.
Insert the slide plate in between the upper clamp plate
and the plastic boot. While pressing the boot firmly
against the mower deck, tighten the (2) wing nuts as
shown in Figure N.
Figure N
Insert Slide Plate In
Between Upper Clamp
Plate And Plastic Boot
Lower Hose Installation
Attach one end of the 7" lower hose to the blower cone
and the other end of the hose to the plastic boot. Secure
the lower hose using (2) hose clamps P#(J0070). Refer
Lower Clamp
to Figure A for reference.
Plate w/ Carriage
Bolts
Note: The lower hose must be cut to fit your machine.
Do not cut the hose until you have tried to fit it on your
machine. Remember that the hose has to be long
enough to allow for enough clamping surface between
the blower cone and the deck boot.
Upper Clamp
Plate
Figure A
7" Lower
Hose
Clamp
Hose
7" Lower
Hose
Advertisement
Table of Contents
