Engine Stay Assembly Installation - Peco X20 Convertible Trailer Vac Operator's Manual

Engine Stay Assembly Installation

Note: Depending on the manufacturer and style of your
tractor, the engine stay assembly mounting procedure
may vary slightly from the instructions listed below.
Cut the zip tie that secures the engine mount arm to the
trailer. Refer to Figure A.
Figure A
Engine
Mount Arm
Rotate the engine towards the deck opening of the
tractor as shown in Figure B. (See Engine Stay
Adjustments, pg. 14 through 17).
Figure B
Rotate
Towards
Deck
Opening
Attach the ball clevis P#(B0132) to the rear left of the
tractor. There should be an existing hole in the tractor
frame for this ball clevis to mount to. Secure the ball
clevis using (1) 3/8"-16 x 1" hex bolt P#(K1191) and (1)
3/8" lock washer P#(K0048).
NOTE: If there is not an existing hole, position the ball
clevis as shown in Figure C, then mark the position. Drill
a hole in the tractor frame using a 3/8" drill bit.
Figure C
Attach the ball clevis clamp assembly P#(A0336) to the
ball clevis using (1) 5/16"-18 x 2" hex bolt P#(K1159) and
(1) 5/16"-18 locknut P#(K2516). Thread the adjusting rod
P#(B4311) into the ball clevis clamp assembly as shown
in Figure D. Insert the adjusting rod into the mounting
hole on the engine mount arm. Secure the adjusting rod
with (1) hair pin clip P#(K0099) and (1) 1/2" flat washer
P#(K0055). Refer to Figure D and E for reference.
Cut Zip
Tie
Ball
Clevis
Nyloc
Rear Frame
Of Tractor
Ball Clevis
Figure D
Adjusting
Ball Clevis
Clamp Assy
Figure E
Hex
Bolt
Nut
Ball
Clevis
Clamp
Rod
Adjusting
Rod
Hair Pin
Clip
and Washer
13