Section V - INSTALLATION FOR USE
Preparation Of Parts
PECO Trailer Vacs are shipped as shown in Figure A.
Note: The following instructions are used in the
installation of both the X20 Trailer Vac & X30 Trailer Vac.
Figure A
Remove the shrink wrap as shown in Figure B.
Figure B
Remove the door as shown in Figure C. Rotate the red
reflectors to release the door. Then lift up and out.
Figure C
Rotate
Reflectors
Remove the hoses as shown in Figure D.
Release the (2) rubber straps (PER SIDE) as shown in
Shipping Crate
Figure E.
Remove the lightweight top as shown in Figure F.
Cut and Remove
Shrink Wrap
Figure D
Figure E
Release
Rubber Straps
Figure F