Table of Contents
Advertisement
Requirements
The laundry is prepared.
¡
→ "Preparing the laundry", Page 29
The laundry is sorted.
¡
The laundry is placed in the appli-
¡
ance.
→ "Loading laundry", Page 30
The programme is set.
¡
→ "Setting a programme", Page 30
The intelligent dosing system is ac-
¡
tivated.
Fill the dispensers.
1.
→ "Filling the dispensers",
Page 33
To replace the contents of the dis-
penser with another product, clean
the detergent drawer.
If required, adjust the basic
2.
dosage → Page 33.
If required, adjust the programme
3.
settings.
→ "Adjusting the programme set-
tings", Page 30
Start the programme.
4.
→ "Starting the programme",
Page 30
Remove the laundry.
5.
→ "Unloading the laundry",
Page 31
15.2 Filling the dispensers
If you want to use the intelligent dos-
ing system or if the appliance dis-
plays a notification during operation
of the appliance, fill the dispensers.
Note: Fill the dispensers only with
suitable detergent and care products
→ Page 29.
If you want to add more liquid deter-
gent or fabric softener in the dis-
penser, use the same product.
If you want to use both dispensers
for liquid detergent, adjust the con-
tents of the dispensers.
Intelligent dosing system en
Requirement: The display shows a
notification to fill the dispenser.
Pull out the detergent drawer.
1.
Open the dispenser cover.
2.
Pour liquid detergent
3.
softener
into the relevant dis-
pensers.
→ "Detergent drawer", Page 18
Do not exceed the marking for the
maximum fill level when filling.
Close the dispenser cover.
4.
Note: To prevent the liquid deter-
gent or fabric softener from drying
out, close the dispenser cover im-
mediately after filling.
If required, pour washing aid into
5.
the compartment for manual dos-
ing.
→ "Adding detergent and care
product", Page 30
Push in the detergent drawer.
6.
Adjust the basic dosage
7.
→ Page 33.
15.3 Basic dosage
The basic dosage depends on the
manufacturer's instructions for the de-
tergent, the water hardness and the
degree of soiling of the laundry.
Always set a basic dosage that cor-
responds to the dosage for a stand-
ard load of 4.5 kg.
Adjusting the basic dosage
Press and hold
1.
seconds.
The display shows the basic
a
dosage set for
To adjust the setting, press .
2.
To end the setting process, wait
3.
briefly.
Note: To adjust the basic dosage for
, repeat the steps with
and fabric
for approx. 3
.
.
33
Advertisement
Table of Contents
