Filling The Dispensers; Basic Dosage - Siemens WG44G2ALDN User Manual And Installation Instructions

Table of Contents

Advertisement

en Intelligent dosing system
15.2 Filling the dispensers
If you want to use the intelligent dos-
ing system or if the appliance dis-
plays a notification during operation
of the appliance, fill the dispensers.
Note: Fill the dispensers only with
suitable detergent and care products
→ Page 30.
If you want to add more liquid deter-
gent or fabric softener in the dis-
penser, use the same product.
If you want to replace the liquid de-
tergent or fabric softener in the dis-
penser with another product, clean
the detergent drawer beforehand.
→ "Cleaning the detergent drawer",
Page 37
Requirement: The display shows a
notification to fill the dispenser.
→ "Display", Page 21
→ "Display", Page 21
Pull out the detergent drawer.
1.
Open the dispenser cover.
2.
34
Pour liquid detergent
3.
softener
into the relevant dis-
pensers.
→ "Detergent drawer", Page 17
Do not exceed the marking for the
maximum fill level when filling.
Close the dispenser cover.
4.
Note: To prevent the liquid deter-
gent or fabric softener from drying
out, close the dispenser cover im-
mediately after filling.
If required, pour washing aid into
5.
the compartment for manual dos-
ing.
→ "Adding detergent and care
product", Page 31
Push in the detergent drawer.
6.
Adjust the basic dosage
7.
→ Page 34.
15.3 Basic dosage
The basic dosage depends on the
manufacturer's instructions for the de-
tergent, the water hardness and the
degree of soiling of the laundry.
Always set a basic dosage that cor-
responds to the dosage for a stand-
ard load of 4.5 kg.
Adjusting the basic dosage
Press and hold
1.
seconds.
a The display shows the basic
dosage set for
and fabric
for approx. 3
.

Advertisement

Table of Contents
loading

Table of Contents