Table of Contents
Advertisement
Quick Links
Single Channel Video Receive Unit with one Bi-directional
Data Channel and two Uni-directional Alarms for a
The AMG5716 is a standalone system designed to receive one video signal and transmit and receive
two uni-directional alarms plus one data signal over a Singlemode optical fibre.
The AMG5716 is designed to be powered using an AMG2001 standalone power supply.
The AMG5716 is designed to operate with an AMG5715 standalone video transmit unit in a point to
point configuration.
AMG Systems Ltd. reserves the right to make changes to this
document without notice. The information herein is believed to
be accurate. No responsibility is assumed by AMG for its use.
Singlemode Fibre Link
AMG5716
Instruction Manual
Page 1 of 8
AMG5716 Instruction Sheet D17054-
04.doc
Advertisement
Table of Contents
Related Manuals for AMG AMG5716
Summary of Contents for AMG AMG5716
- Page 1 Singlemode optical fibre. The AMG5716 is designed to be powered using an AMG2001 standalone power supply. The AMG5716 is designed to operate with an AMG5715 standalone video transmit unit in a point to point configuration.
- Page 2 Removal / replacement from / to the Case..................8 Safety Maintenance and Repair AMG Systems Ltd. reserves the right to make changes to this Page 2 of 8 AMG5716 Instruction Sheet D17054- document without notice. The information herein is believed to 04.doc...
- Page 3 AMG5715. Optical Connection The AMG5716 connections are illustrated in the following example which shows an AMG5715 single channel transmit unit together with a AMG5716 configured as a point to point system. AMG Systems Ltd. reserves the right to make changes to this...
- Page 4 Connections Video Output Connection Connector ..........75 ohm BNC Socket. Output Impedance .......75 ohm terminated. Output Level ........1 Volt p-p nominal Frequency Response......10Hz to 7MHz. Optical Connections Singlemode No. of Optical Connections ....1 per video channel Optical Fibre ........Singlemode Connector ..........SC/PC Primary Optical Launch Power ....-10dBm Transmit Wavelength......1550nm Primary Optical Sensitivity ....-30dBm...
- Page 5 RS-485 bus high (+5 volts) and the other arm low (0 volts) using high value resistors within the third party equipment. In order to ensure that the AMG equipment detects a tri-state condition, then these resistors should have a value above 5kΩ. If the third party bias resistors are less the 750Ω...
- Page 6 Note: (A) or (B) in brackets in the above table refers to RS-485 / RS-422 data specification. Alarm Channel Configuration The AMG5716 provides 2 uni-directional alarm outputs. Each alarm output uses a solid-state relay, maximum current 150mA at 125Vac/dc and Ron < 6.5Ω.
- Page 7 Front Panel Indicators Power LED Power / Video / Opto ......Green Video present & opto sync. Opto sync. but no video present. No opto sync. No power applied to unit. Low Speed Data LEDs Data Present IN (RS485 or RS422) ..Green logic zero (+V, -V) present on IN+, IN- logic one (-V,V+) present on IN+, IN- tri-state off or no connection on IN+, IN-...
- Page 8 Weight..........500grams Mounting Details The AMG unit is supplied with a clip-on mounting bracket which should be attached to a panel or wall using 2 off 4.0mm screws, see diagram on page 1 for dimensions. The unit is clipped into the mounting bracket, and is then held firmly in position.
Need help?
Do you have a question about the AMG5716 and is the answer not in the manual?
Questions and answers