Table of Contents
Advertisement
Quick Links
Single Channel Video Receive Unit with one Bi-directional
Data Channel and two Uni-directional Alarms for a
The AMG5616 is a standalone system designed to receive one video signal and transmit and receive
two uni-directional alarms plus one data signal over a Multimode optical fibre.
The AMG5616 is designed to be powered using an AMG2001 standalone power supply.
The AMG5616 is designed to operate with an AMG5615 standalone video transmit unit in a point to
point configuration.
AMG Systems Ltd. reserves the right to make changes to this
document without notice. The information herein is believed to
be accurate. No responsibility is assumed by AMG for its use.
Multimode Fibre Link
AMG5616
Instruction Manual
Page 1 of 8
AMG5616 Instruction Sheet D17084-
02.doc
Advertisement
Table of Contents
Related Manuals for AMG AMG5616
Summary of Contents for AMG AMG5616
- Page 1 Multimode optical fibre. The AMG5616 is designed to be powered using an AMG2001 standalone power supply. The AMG5616 is designed to operate with an AMG5615 standalone video transmit unit in a point to point configuration.
-
Page 2: Table Of Contents
Removal / replacement from / to the Case..................8 Safety Maintenance and Repair AMG Systems Ltd. reserves the right to make changes to this Page 2 of 8 AMG5616 Instruction Sheet D17084- document without notice. The information herein is believed to 02.doc... -
Page 3: Introduction
AMG5615. Optical Connection The AMG5616 connections are illustrated in the following example which shows an AMG5615 single channel transmit unit together with a AMG5616 configured as a point to point system. AMG Systems Ltd. reserves the right to make changes to this... -
Page 4: Connections
RS-422 – Switch Position - Middle RS-232 – Switch Position - Bottom Alarm Outputs ........Solid-state Relay, maximum 150mA at 125Vac/dc, Ron < 6.5Ω AMG Systems Ltd. reserves the right to make changes to this Page 4 of 8 AMG5616 Instruction Sheet D17084- document without notice. -
Page 5: Data And Alarm Channel Configuration
RS-485 bus high (+5 volts) and the other arm low (0 volts) using high value resistors within the third party equipment. In order to ensure that the AMG equipment detects a tri-state condition, then these resistors should have a value above 5kΩ. If the third party bias resistors are less the 750Ω... -
Page 6: Data Interface Connections
ALARM 2 OUT + ALARM 1 OUT - ALARM 1 OUT + AMG Systems Ltd. reserves the right to make changes to this Page 6 of 8 AMG5616 Instruction Sheet D17084- document without notice. The information herein is believed to 02.doc... -
Page 7: Front Panel Indicators
ALARM 2 OUT........Green Alarm ON / Contacts closed. Alarm OFF / Contacts open. AMG Systems Ltd. reserves the right to make changes to this Page 7 of 8 AMG5616 Instruction Sheet D17084- document without notice. The information herein is believed to 02.doc... -
Page 8: Physical Information
Weight..........500grams Mounting Details The AMG unit is supplied with a clip-on mounting bracket which should be attached to a panel or wall using 2 off 4.0mm screws, see diagram on page 1 for dimensions. The unit is clipped into the mounting bracket, and is then held firmly in position.
Need help?
Do you have a question about the AMG5616 and is the answer not in the manual?
Questions and answers