Table of Contents
Advertisement
Quick Links
Dual System with 2x Independent Channels each of :
[Receive Unit with one Bi-directional Data Channel and two
Uni-directional Alarms for a Singlemode Fibre Link]
The AMG5526 is a DUAL standalone system which provides two independent channels, each
designed to receive 2 uni-directional alarms and transmit and receive 1 data signal over one
Singlemode optical fibre.
The AMG5526 is designed to be powered using an AMG2001 standalone power supply.
The AMG5526 is designed to operate with two AMG5515 single channel or one AMG5525 /
AMG5525R dual channel transmit unit in a point to point configuration. The R suffix in the partno.
indicates a rackmount configuration.
AMG Systems Ltd. reserves the right to make changes to this
document without notice. The information herein is believed to
be accurate. No responsibility is assumed by AMG for its use.
AMG5526
Instruction Manual
Page 1 of 8
AMG5526 Instruction Sheet D17299-
00.doc
Advertisement
Table of Contents
Related Manuals for AMG AMG5526
Summary of Contents for AMG AMG5526
- Page 1 The AMG5526 is designed to be powered using an AMG2001 standalone power supply. The AMG5526 is designed to operate with two AMG5515 single channel or one AMG5525 / AMG5525R dual channel transmit unit in a point to point configuration. The R suffix in the partno.
- Page 2 Removal / replacement from / to the Case ..................8 Safety Maintenance and Repair AMG Systems Ltd. reserves the right to make changes to this Page 2 of 8 AMG5526 Instruction Sheet D17299- document without notice. The information herein is believed to 00.doc...
- Page 3 AMG5526 Optical Connection The AMG5526 connections are illustrated in the following example which shows an AMG5526 transmit unit together with an AMG5525 two channel standalone transmit unit configured as a dual channel point to point system.
- Page 4 RS-422 – Switch Position - Middle RS-232 – Switch Position - Bottom Alarm Output ........Solid-state Relay, maximum 150mA at 125Vac/dc, Ron < 6.5Ω AMG Systems Ltd. reserves the right to make changes to this Page 4 of 8 AMG5526 Instruction Sheet D17299- document without notice.
- Page 5 ALARM 2 OUT........Green Alarm ON / Contacts closed. Alarm OFF / Contacts open. AMG Systems Ltd. reserves the right to make changes to this Page 5 of 8 AMG5526 Instruction Sheet D17299- document without notice. The information herein is believed to 00.doc...
- Page 6 RS-485 bus high (+5 volts) and the other arm low (0 volts) using high value resistors within the third party equipment. In order to ensure that the AMG equipment detects a tri-state condition, then these resistors should have a value above 5kΩ. If the third party bias resistors are less the 750Ω...
- Page 7 ALARM 2 OUT + ALARM 1 OUT - ALARM 1 OUT + AMG Systems Ltd. reserves the right to make changes to this Page 7 of 8 AMG5526 Instruction Sheet D17299- document without notice. The information herein is believed to 00.doc...
- Page 8 Weight ..........600grams Mounting Details The AMG unit is supplied with a clip-on mounting bracket which should be attached to a panel or wall using 2 off 4.0mm screws, see diagram on page 1 for dimensions. The unit is clipped into the mounting bracket, and is then held firmly in position.
Need help?
Do you have a question about the AMG5526 and is the answer not in the manual?
Questions and answers