Turning Active Lane Management On Or Off; Active Lane Management Warning Message - Jeep Compass 2023 Owner's Manual

If the driver continues to drift out of the lane, the system
provides a flashing visual warning through the instrument
cluster display as well as a haptic steering wheel vibration
(if configured in Uconnect Settings) when the vehicle
crosses the lane boundary.
NOTE:
When operating conditions have been met, the Active
Lane Management system will monitor if the driver's
hands are on the steering wheel and provides an audible
and visual warning to the driver if removed. The system
will cancel if the driver does not return their hands to the
wheel.
T A L M
URNING CTIVE ANE ANAGEMENT
O O O
N R FF
The Active Lane Management button is located
on the switch panel below the Uconnect
display.
To turn the system on, push the Active Lane Management
button (LED turns off). A message is shown in the
instrument cluster display.
To turn the system off, push the button again
(LED turns on).
NOTE:
The Active Lane Management system will retain the
last system state on or off from the last ignition cycle when
the ignition is placed in the ON/RUN position.
A L M
CTIVE ANE ANAGEMENT
M
ESSAGE
The Active Lane Management system will indicate the
current lane drift condition through the instrument cluster
display.
When the system is on, the lane lines are gray when both
of the lane boundaries have not been detected.
System On (Gray Lines)
Left Lane Departure — Only Left Lane Detected
 When the system is on and only the left lane marking
has been detected, and the system is ready to provide
visual warnings in the instrument cluster display and a
vibration and/or steering assist warning in the steering
wheel if a lane departure occurs, the left lane line will
be green.
STARTING AND OPERATING
W
 When the system senses the lane line has been
ARNING
approached (but not crossed), the left lane line will
change to solid yellow and the system will provide a
haptic steering wheel vibration and/or steering assist
torque (if programmed in Uconnect Settings).
 When the system senses the lane line is being crossed,
the left lane line will change to flashing yellow.
Lane Crossed (Flashing Yellow Line)
NOTE:
The Active Lane Management system operates with
similar behavior for a right lane departure when only the
right lane marking has been detected.
129
4