Jeep Compass 2023 Owner's Manual page 63

NOTE:
 Before closing the liftgate, make sure to be in posses-
sion of the key fob because the liftgate may be locked.
 Use the interior door lock/unlock button on the door
panel or the key fob to lock and unlock the liftgate. The
manual door locks on the doors and the exterior door
lock cylinder will not lock and unlock the liftgate.
 The liftgate will either unlock along with the vehicle
doors, or it will need to be unlocked by pushing the
electronic liftgate release, depending on the selected
setting in the Uconnect system
Ú page 145.
 The power liftgate buttons will not operate if the
vehicle is in gear or the vehicle speed is above
0 mph (0 km/h).
 The power liftgate will not operate in temperatures
below −22°F (−30°C) or temperatures above
150°F (65°C). Be sure to remove any buildup of
snow or ice from the liftgate before pushing any of
the power liftgate switches.
 If anything obstructs the power liftgate while it is
closing or opening, the liftgate will automatically
reverse to the closed or open position. After multiple
obstructions in the same cycle, the liftgate will auto-
matically stop and must be opened or closed manually.
 There are pinch sensors attached to the side of the lift-
gate. Light pressure anywhere along these strips will
cause the liftgate to return to the open position.
 The power liftgate must be in the full open position in
order for the rear liftgate close button, on the left rear
trim near the liftgate opening, to operate. If the liftgate
is not fully open, push the liftgate button on the key fob
to fully open the liftgate and then push it again to close.
 If the electronic liftgate release handle is pushed a
second time while the power liftgate is opening, the
liftgate motor will disengage to allow manual operation.
 If your liftgate is power closing and you put the vehicle
in gear, the liftgate will continue to power close.
However, vehicle movement may result in the detec-
tion of an obstruction.
 Allow the power system to open the liftgate. Manually
pushing or pulling the liftgate may activate the liftgate
obstacle detection feature and stop the power opera-
tion or reverse its direction.
WARNING!
 Driving with the liftgate open can allow poisonous
exhaust gases into your vehicle. You and your
passengers could be injured by these fumes.
Keep the liftgate closed when you are operating
the vehicle.
 If you are required to drive with the liftgate open,
make sure that all windows are closed, and the
climate control blower switch is set at high speed.
Do not use the recirculation mode.
 During power operation, personal injury or cargo
damage may occur. Ensure the liftgate travel path is
clear. Make sure the liftgate is closed and latched
before driving away.
 Personal injury or cargo damage may occur if caught
in the path of the liftgate. Make sure the liftgate path
is clear before activating the liftgate.
GETTING TO KNOW YOUR VEHICLE
H -F L — I
ANDS REE IFTGATE F
Hands-Free Liftgate Activation Zone
To open or close the liftgate using hands-free activation,
use a straight in and out kicking motion under the vehicle
activation zone in the general location below the rear
license plate. The activation zone is about 1.8 ft (0.5 m)
from side to side. Do not move your foot sideways or in a
sweeping motion or the sensors may not detect the
motion.
NOTE:
Activation zone is the same for vehicles equipped with or
without a trailer tow package.
When a valid kicking motion is completed, the liftgate will
chime, the hazard lights will flash and the liftgate will
open after approximately one second, or close after
approximately three seconds. These settings can be
enabled or disabled through Uconnect Settings
page 145.
Ú
61
E
QUIPPED
2