Table of Contents
Advertisement
Function Introduction for Combination Buttons
Child lock function
Pressing "+" and "-" buttons simultaneously can turn on or turn off child lock function.When child lock function is started up,
LOCK indicator on remote controller is ON.If you operate the remote controller, remote controller won't send signal.
Temperature display switchover function
Under OFF status, pressing "-" button and "MODE" button simultaneously can switch between °C and °F.
Light function
Under switch-on or switch-off state, you may hold "+"and "FAN" buttons simultaneously for 3 seconds to set the lamp on or off
and send the code. After being energizedthe lamp is defaulted on.
If "H1" is displayed on the remote controller while it's not operated by the professional person/after-sales person, it belongs to the misoperation.
Please operate it as below to cancel it.Under the OFF status of remote controller, hold the "MODE" button and "X-FAN" buttons simultaneously
for 5s to cancel "H1" display.
Note:
If remote controller displays "H1", it belongs to the normal function reminder. If the unit is defrosting under heating mode, it operates according
to H1 defrosting mode. "H1" won't be displayed on the panel of indoor unit;
Once you set H1 mode, if you turn off unit by remote controller, H1 will display 3 times on the remote controller and then disappear;
Also, when you set H1 mode, when you change to heating mode, H1 will display 3 times on the remote controller and then disappear.
Operation Guide
1.
After putting through the power, press "ON/OFF" button on remote controller to turn on the air conditioner.
2.
Press "MODE" button to select your required mode: COOL, DRY, FAN.
3.
Press "+" or "-" button to set your required temperature. (Temperature can't be adjusted under auto mode).
4.
Press "FAN" button to set your required fan speed: auto, low, medium and high speed.
Replacement of Batteries in Remote Controller
1.
Press the back side of remote controller on the spot marked with "
and then push out the cover of battery box along the arrow direction.
2.
Replace two No.7 (AAA 1.5V) dry batteries and make sure the positions
of + and - polar are correct.
3. Reinstall the cover of battery box.
NOTICE
During operation, point the remote control signal sender at the receiving
window on the unit.
The distance between signal sender and receiving window should be no more
than 8m, and there should be no obstacles between them.
or wireless telephone; remote controller should be close to the unit during
operation.
Replace new batteries of the same model when replacement is required.
When you don't use remote controller for a long time, please take out the
batteries.
If the display on remote controller is fuzzy or there's no display, please
replace batteries.
21
",
cover of battery box
Service Manual
battery
reinstall
remove
Technical Information
Advertisement
Table of Contents
