Gree ALTEA Service Manual page 35

Hole
Projection
Service Manual
Rain guard
2.Attach the guard combined above to the window panel.
Push the insect guard net firmly to ensure that its four projections fit into the holes in the window panel.
Side "A" will now be at the top, as indicated in the diagram, when it is installed inthe window.
Window panel
"A"
Projection
3.Cut the Foam seal B (adhesive type) to the proper length and attach it to the window frame and to the side of sash.
Foam seal B (adhesive type)
4.Install the window panel into the window frame.Make sure that the exhaust cover is attached to the window panel.Inner height of
the window:20.5"(520mm)Use the window panel.
The window panel cannot be installed in windows less than 20.5" (520mm) high, as you will be unable to shut the exhaust cover.
(1) Open the window sash and place the window panel on the window frame.
(2) Secure the window panel to the window frame with screws.
Exhaust cover
Window panel
20.5"
Inner height of the window:20.5" (520mm)- 37.4" (950mm) Use the window panel and the adjustment panel.
(1) Open the window sash and place the window panel on the window frame.
(2) Slide the adjustment panel to fit the window frame height.
(3) Secure the window panel to the window frame with screws.
Adjustment panel
20.5" - 37.4"
Maintenance
33
Extension panel