Clock Settings; Timer Function Settings - Hayward ENERGYLINE PRO Installation Instructions Manual

4. USER INTERFACE (continued)
At the end of a setting, press
The settings will be automatically saved if no button is pressed during 20s.

4.2 Clock settings

If the display is in standby mode, press briefly on
1) Press to bring up the symbol
2) Press
to make the time display flash. Set the hour using the buttons
.
3) Press then set the minutes with the buttons
4) Press to validate.

4.3 Timer function settings

Setting this function is necessary if you would like to run the heat pump for
a shorter period than what is defined by the filtration clock. Therefore, you
can program a deferred start and an anticipated stop or simply stop a certain
timeframe from running (at night, for example).
It is possible to set 2 Start Timers (ON1 et ON2) and 2 Stop Timers (OFF1 et
OFF2).
Timer 1 setting – Start
1) Press
for 2s, Timer ON1
2) Press to set the hours with the buttons
3) Press to set the minutes with the buttons
4) Press to validate.
Timer 1 setting – Stop
1) Press
for 2s, Timer ON1
Press once, Timer OFF1
2) Press to set the hours with the buttons
3) Press to set the minutes with the buttons
4) Press
to validate.
(*) To access Timer ON2
16
to validate.
.
flashes (*).
flashes (*).
flashes.
directly, press
.
.
.
.
.
..
for 2s, then press twice.