Table of Contents
Advertisement
Figure 65. Installing the drive bay cage blank
Next steps
1. If removed,
install the front bezel.
2. Follow the procedure listed in
Removing a drive bay
Prerequisites
1. Follow the safety guidelines listed in
2. Follow the procedure that is listed in
3.
Remove all the
drives.
4.
Remove the backplane from drive
Steps
1. Using the Phillips 2 screwdriver, remove the screws securing the drive bay to the system.
2. Slide the drive bay out of the system.
NOTE:
The procedure to remove the drive bays is similar for all configurations.
72
Installing and removing system components
After working inside your
Safety
instructions.
Before working inside your
bay.
system.
system.
Advertisement
Table of Contents
