Table of Contents
Advertisement
Figure 143. Removing the retaining clip
Next steps
Replace the
processor.
Installing the processor
Prerequisites
1. Follow the safety guidelines listed in
2. Follow the procedure that is listed in
3.
Remove the air
shroud.
4.
Remove the processor heat sink
Steps
1. Place the processor in the processor tray.
NOTE:
Ensure the pin 1 indicator on the processor tray is aligned with the pin 1 indicator on the processor.
2. Place the retaining clip on top of the processor in the processor tray aligning pin 1 indicator on the processor.
NOTE:
Ensure the pin 1 indicator on the retaining clip is aligned with the pin 1 indicator on the processor before placing
the retaining clip on the processor.
NOTE:
Before you install the heat sink, ensure to place the processor and retaining clip in the tray.
Safety
instructions.
Before working inside your
module.
system.
Installing and removing system components
141
Advertisement
Table of Contents
