System Status; Lan Segment Led Status - TRENDnet TE100-S14 User Manual

System Status

If the System passes the POST sequence and all LAN ports are
2 -
operational, all LEDs - will be off (See Figure Chapter
6
on Page 17).
If there is a System error, the LED light will be On, and the
LEDs - will display the System error code.
Some of the System errors and LAN port errors can be resolved
by restarting the System, or with remote technical support from
TRENDware (See shaded areas in Appendix A, Page 35,
The TE-
). The remaining System
100/S14 system POST status LED lights
errors require that the unit be returned to your nearest TRENDnet
reseller for repair.

LAN segment LED Status

In addition to the System Status LED lights, there are three LED
lights (See Page 36) for each port displaying the operating status
of the connected 10Mbps or 100Mbps LAN segment.
Each Link LED light displays the status of corresponding LAN
segment during Power-On.
During active switching of LAN data traffic, Link LED lights
display the change in the state of the segment, Activity LED
lights display the transmitting and receiving of data on the
corresponding LAN segments. The Collision LED lights reflect
the efficiency of carrying meaningful data traffic. Users should
re-arrange workgroups sharing a LAN segment when the
Collision LED stays on consistently for this segment. For
example, on a segment with dedicated end-station connection, the
Collision LED should stay off all the time.
34