Setup; Checking Status Led Lights - TRENDnet TE100-S14 User Manual

If a cable is used for connecting a port to a workstation, just use
the standard UTP cable connectors with the RJ-45 pin layout.
If a cable is used for connecting to a hub, bridge, or another
switch, the Transmit (TD) and the Receive (RD) leads on one end
of the connectors must be swapped. Please refer to Appendix D
for pin layout details.
S
ETUP
The default setup of the TE-100/S14 Switch (shown in Appendix
B) should work in the majority of installations. If a different
setting is required for your specific networking environment,
please refer to the Out-of-Band Management section in Chapter 3,
"Configuring the Switch," for changing these default settings.
C S LED
HECKING TATUS LIGHTS
When the power is first turned on, the TE-100/S14 Switch
performs a Power-On Self Test (POST). Please observe the status
LED lights to verify a proper installation (refer to Appendix A,
Page 35). These status LED lights also provide information about
the system unit and its connected Ethernet or Fast Ethernet LAN
segments during normal operation.
Figure Chapter 2 -6, The system status LED lights
17