Table of Contents
Advertisement
SATA Configuration
SATA0
SATA 0 Enable controller
This item enables or disables the onboard SATA controller supported by the processor. The
options are Enabled and Disabled.
SATA 0 ALPM
When this feature is set to Enabled, the SATA AHCI controller manages the power usage of
the SATA link. The controller will put the link in a low power mode during extended periods
of I/O inactivity and will return the link to an active state when I/O activity resumes. The
options are Enabled and Disabled.
*If the feature above is set to Enabled, SATA 0 ALPM will be available for configuration:
SATA 0 LPM
Use this feature to enable or disable Aggressive Link Power Management. The options are
Enabled and Disabled.
SATA 0 SGPIO/LED
Use this feature to select SATA SGPIO or SATA LED. The options are SATA SGPIO and
SATA LED.
I-SATA (M.2 - B Key)
This following information is displayed for each M.2 drive entry:
•
Device Information:
•
Device Size:
I-SATA (M.2 - B Key) Enable/disable port
Use this feature to disable or enable the SATA port number. The options are Enabled
and Disabled.
I-SATA (M.2 - B Key) Spin up
When the value of an edge detect or the value of an image binary (pixel) of a device is
from 0 to 1, select Enabled to allow the PCH to start a COMRESET initialization sequence
on this device. The options are Enabled and Disabled.
53
Chapter 5 BIOS
Advertisement
Table of Contents
