Attaching/Disconnecting The Battery Pack To/From The Appliance; Checking The Battery Charge Level; Use; Switching On And Off - Parkside 310452 1904 Translation Of The Original Instructions

♦ Connect the battery pack
battery charger
♦ Insert the power plug into the socket . The control
LED lights up red .
♦ The green LED indicates that the charging
process is complete and the battery pack
is ready for use .
CAUTION!
♦ If the red control LED
that the battery pack
cannot be charged .
♦ If the red and green control LEDs
flash, this means that the battery pack
defective .
♦ Push the battery pack
♦ Switch off the charger for at least 15 minutes
between successive charging sessions . Also dis-
connect the power plug from the mains power
socket .
Attaching/disconnecting the battery
pack to/from the appliance
Attaching the battery pack:
♦ Push the rotation direction switch
middle position (lock) . Push the battery pack
into the handle until it clicks into place .
Removing the battery pack:
♦ Press the release button
battery pack .

Checking the battery charge level

♦ Press the battery charge level button
the status of the battery (see also main diagram) .
The status/remaining charge will be shown on
the battery display LED
♦ RED/ORANGE/GREEN = maximum charge
RED/ORANGE = medium charge
RED = low charge – charge the battery
PASSK 20-Li A1
to the high-speed
(see Fig . A) .
flashes, this means
has overheated and
both
back into the appliance .
into the
and remove the
to check
as follows:

Use

Switching on and off

Switching on:
♦ To start the appliance, press the ON/OFF
switch and keep it pressed in .
The LED working light
ON/OFF switch
This provides illumination of the work area in
poor lighting conditions .
Switching off:
♦ Release the ON/OFF switch
appliance .
Setting/preselecting the rotation
is
speed/tightening torque
♦ Press the torque preselection button
the required torque in stages .
♦ Press the ON/OFF switch
speed/tightening torque . Increasing the pres-
sure increases the speed/tightening torque .
■ The tightening torque depends on the selected
speed/torque preselection and impact duration .
NOTE
► However, to tighten lug nuts, the smallest
torque setting must be selected to avoid over
tightening .
CAUTION!
♦ The tightening torque actually attained must
always be checked with a torque wrench!
NOTE
► The integrated motor brake ensures rapid
stoppage .

Changing the direction of rotation

♦ Change the direction of rotation by pressing
the rotation direction switch
or right .

Fitting the socket

♦ Push one of the supplied sockets
tool holder
lights up when the
is depressed lightly or fully .
to switch off the
lightly for a low
towards the left
onto the
.
GB │ IE
to select
│ 19 ■