Attaching/Disconnecting The Battery Pack To/From The Appliance; Checking The Battery Charge Level; Use; Switching On And Off - Parkside 320332 Original Instructions Manual

Attaching/disconnecting the battery
pack to/from the appliance
Attaching the battery pack:
♦ Push the rotation direction switch
middle position (lock). Push the battery pack
into the handle until it clicks into place.
Removing the battery pack:
♦ Press the release button
battery pack .

Checking the battery charge level

♦ Press the battery charge level button
the status of the battery (see also main diagram).
The status/remaining charge will be shown
on the battery display LED
♦ RED/ORANGE/GREEN = maximum charge
RED/ORANGE = medium charge
RED = low charge – charge the battery

Use

Switching on and off
Switching on:
♦ To start the appliance, press the ON/OFF
switch and keep it pressed in.
The LED working light
ON/OFF switch
This provides illumination of the work area in
poor lighting conditions.
Switching off:
♦ Release the ON/OFF switch
appliance.
Setting/preselecting the rotation
speed/tightening torque
♦ Press the torque preselection button
the required torque in stages.
♦ Press the ON/OFF switch
speed/tightening torque. Increasing the pres-
sure increases the speed/tightening torque.
■ The tightening torque depends on the selected
speed/torque preselection and impact duration.
PASSK 20-Li A1
into the
and remove the
to check
as follows:
lights up when the
is depressed lightly or fully.
to switch off the
to select
lightly for a low
NOTE
► However, to tighten lug nuts, the smallest
torque setting must be selected to avoid over
tightening.
CAUTION!
♦ The tightening torque actually attained must
always be checked with a torque wrench!
NOTE
► The integrated motor brake ensures rapid
stoppage.

Changing the direction of rotation

♦ Change the direction of rotation by pressing
the rotation direction switch
or right.

Fitting the socket

♦ Push one of the supplied sockets
tool holder .

Maintenance and cleaning

WARNING! RISK OF INJURY! Always
switch off the appliance and remove
the battery before carrying out any
work on the appliance.
The appliance is maintenance-free.
■ The appliance must always be kept clean, dry
and free from oil or grease.
■ Never allow liquids to get into the appliance.
■ Use a soft, dry cloth to clean the housing.
Never use petrol, solvents or cleansers which
can damage plastic.
■ If a lithium-ion battery is to be stored for an
extended period, the charge level should be
checked regularly. The optimum charge level is
between 50% and 80%. The optimum storage
environment is cool and dry.
NOTE
► Replacement parts not listed (such as carbon
brushes, switch) can be ordered via our
service hotline.
towards the left
onto the
GB │ IE │
21 ■