Before use
Charging the battery pack (see fig. A)
CAUTION!
►
Always pull out the power plug before you
remove the battery pack from or connect the
battery pack to the charger.
■
Never charge the battery pack
ambient temperature is below 10°C or above
40°C.
♦
Connect the battery pack
battery charger
♦
Insert the power plug into the socket. The control
LED
lights up red.
♦
The green LED
indicates that the charging
process is complete and the battery pack
is ready for use.
CAUTION!
♦
If the red control LED
that the battery pack
cannot be charged.
♦
If the red and green control LEDs
flash, this means that the battery pack
defective.
♦
Push the battery pack
♦
Switch off the charger for at least 15 minutes
between successive charging sessions. Also dis-
connect the power plug from the mains power
socket.
Attaching/disconnecting the battery
pack to/from the appliance
Attaching the battery pack:
♦
Push the rotation direction switch
middle position (lock). Push the battery pack
into the handle until it clicks into place.
PASSK 20-Li A1
when the
to the high-speed
(see Fig. A).
flashes, this means
has overheated and
both
back into the appliance.
into the
Removing the battery pack:
♦
Press the release button
battery pack
Checking the battery charge level
♦
Press the battery charge level button
the status of the battery (see also main diagram).
The status/remaining charge will be shown
on the battery display LED
♦
RED/ORANGE/GREEN = maximum charge
RED/ORANGE = medium charge
RED = low charge – charge the battery
Use
Switching on and off
Switching on:
♦
To start the appliance, press the ON/OFF
switch
and keep it pressed in.
The LED working light
ON/OFF switch
This provides illumination of the work area in
poor lighting conditions.
Switching off:
♦
Release the ON/OFF switch
is
appliance.
Setting/preselecting the rotation
speed/tightening torque
♦
Press the torque preselection button
the required torque in stages.
♦
Press the ON/OFF switch
speed/tightening torque. Increasing the pres-
sure increases the speed/tightening torque.
■
The tightening torque depends on the selected
speed/torque preselection and impact duration.
NOTE
►
However, to tighten lug nuts, the smallest
torque setting must be selected to avoid over
tightening.
CAUTION!
♦
The tightening torque actually attained must
always be checked with a torque wrench!
and remove the
.
as follows:
lights up when the
is depressed lightly or fully.
to switch off the
lightly for a low
GB │ MT
│
to check
to select
19
■