Installing Gas Supply - Miller MigMatic CE 260i Owner's Manual

4-3.

Installing Gas Supply

3-3. Installing Gas Supply
19/32 in. (15 mm)
wrench
crescent wrench
OM-287348 Page 12
OM-287348 Page 16
4
Argon Gas Or Mixed Gas
OR
7
5
8
6
Rear Panel
Ref. 148265-B / Ref. 149827-B / Ref. 158697-A Ref. 9561172373_6-A
1
2
3
1
2
3
9
CO Gas
2
Obtain gas cylinder and chain to running
gear, wall, or other stationary support so cyl-
inder cannot fall and break off valve.
1 Cap
2 Cylinder Valve
Remove cap, stand to side of valve, and
open valve slightly. Gas flow blows dust and
dirt from valve. Close valve.
3 Cylinder
4 Regulator/Flowmeter
Install so face is vertical.
5 Regulator/Flowmeter Gas
Connection
6 Welding Power Source
Connection
Connect supplied gas hose between regula-
tor/flowmeter gas hose connection, and fit-
ting on rear of welding power source.
7 Flow Adjust
Typical flow rate is between 15-20 liters per
minute. Check wire manufacturer's recom-
mended flow rate.
8 CO Adapter (Customer Supplied)
2
9 O-Ring (Customer Supplied)
Install adapter with O-ring between regula-
tor/flow meter and CO cylinder.
2
Tools Needed:
19/32 in (15 mm)
Hose
Gas Hose