How To Read This Instruction Manual - Danfoss FC 301 Instruction Manual

VLT ® AutomationDrive FC 300 Instruction
Manual

1. How to Read this Instruction Manual

1.1.1. How to Read this Instruction Manual
VLT ® AutomationDrive FC 300 is designed to provide high shaft performance on electrical motors.
Please read this manual carefully for proper use. Incorrect handling of the adjustable frequency
drive may cause improper operation of the adjustable frequency drive or related equipment,
shorten lifetime or cause other problems.
This Instruction Manual will help you get started and install, program, and troubleshoot your
VLT ® AutomationDrive FC 300.
The VLT
tionDrive FC 300 comes in two shaft performance levels. FC 301 ranges from scalar (U/f) to VVC
+ and handles asynchronous motors only. The FC 302 is a high performance adjustable frequency
drive for asynchronous as well as permanent motors and handles various kinds of motor control
principles such as scalar (U/f), VVC+ and Flux vector motor control.
This Instruction Manual covers both the FC 301 and the FC 302. Where information covers both
series, we refer to the FC 300. Otherwise, we refer specifically to either the FC 301 or the FC 302.
Chapter 1, How to Read this Instruction Manual, introduces the manual and informs you
about the approvals, symbols, and abbreviations used in this literature.
Chapter 2, Safety Instructions and General Warnings, contains instructions on how to handle
the FC 300 correctly.
Chapter 3, How to Install, guides you through mechanical and technical installation.
Chapter 4, How to Program, shows you how to operate and program the FC 300 via the Local
Control Panel.
Chapter 5, General Specifications, contains technical data about the FC 300.
Chapter 6, Troubleshooting, assists you in solving problems that may occur when using the FC
300.
®
AutomationDrive FC 300 comes in twoshaft performance levels. The VLT
MG.33.A9.22 - VLT is a registered Danfoss trademark
1. How to Read this Instruction Manual
1
®
Automa-
3