Table of Contents
Advertisement
Figure 11.10 Securing Tabs Inside Front of Splatter Guard
Once plumbing and wiring are complete on the fireplace,
the lower access panel may be closed until the time that
the splatter guard must be removed for firing the appliance.
Figure 11.11 Splatter Guard with Lower Access Panel Open
To Close the Lower Access Panel:
Carefully disengage the tabs from the square holes and
bend the access panel to its original position. Bend the
center bottom flap and insert it into the bottom of the ap-
pliance.
Figure 11.12 Splatter Guard with Lower Access Panel Closed
To Remove the Splatter Guard:
Carefully grab splatter guard on or near the vertical cen-
ter on the left and right sides. Pull outward gently, but
firmly, taking care not to tear or remove the inserted tabs.
Heat & Glo • ST-36TR-IFT, PIER-36TR-IFT Installation Manual • 2482-980 Rev. D • 3/19
C. Clean the Appliance
Clean/vacuum any sawdust that may have accumulated
inside the firebox or underneath in the control cavity.
61
Advertisement
Table of Contents
