Finishing Material - Heat & Glo PIER-36TR-IFT Installation Manual

TOP VIEW
FIREPLACE
OPENING
3-1/4 in. Min.
Note: Clearance from opening to perpendicular wall.
Figure 10.6 Combustible Mantel Leg or Wall Projections
(Acceptable on both sides of opening)
TOP VIEW
FIREPLACE
OPENING
ST-36TR-IFT=6 IN. MAX.
PIER-36TR-IFT=4 IN. MAX.
Figure 10.7 Non-Combustible Mantel Leg
(Acceptable on both sides of opening)
Heat & Glo • ST-36TR-IFT, PIER-36TR-IFT Installation Manual • 2482-980 Rev. D • 3/19
1/2 in.
Min.
2-3/4
in. Min.
Unlimited
1 in.
Max.
1/2 in.
Min.
Unlimited
3-1/4 in. Min.
C. Finishing Material
Only decorative fronts certified for use with this appli-
ance model may be used. Contact your dealer for a list
of decorative fronts that may be used. Once you have
determined what kind of decorative front and finishing
material is going to be used on the fireplace, you may use
the table below which shows the decorative front models
and the finishing material thickness allowed. For an inside
fit there is an available template to assist with sizing the

finishing material.

ST-36TR-IFT
DECORATIVE
FIT
FRONT
Folio Inside
Overlap
Arcadia
Inside
Overlap
Halston
Inside
Overlap
Chateau
Inside
Overlap
Galleria
Inside
PIER-36TR-IFT
DECORATIVE FRONT FIT
Folio Inside
Chateau Inside
Arcadia Inside
FINISHING MATERIAL
Stop finishing material flush with opening.
Figure 10.8 Folio Decorative Front
FRONT FACE OF FIREPLACE
DOOR
Finishing materials 1 inch maximum thick.
Stop finishing material flush with opening.
Figure 10.9 Overlap Fit Decorative Front
FINISH MATERIAL
SEE
MAXIMUM
FIGURE
THICKNESS
Any 10.8
1 inch 10.9
Any 10.10
1 inch 10.9
Any 10.10
1 inch 10.9
Any 10.10
1 inch 10.9
Any 10.11
FINISH MATERIAL
SEE
MAXIMUM
FIGURE
THICKNESS
Any 10.12
Any 10.12
Any 10.12
DOOR
FINISHING MATERIAL
1 in. MAX
FINISHING MATERIAL
(TOP EDGE)
57