Table of Contents
Advertisement
8-port Ultra60 PoE++ Multi-Gigabit (2.5G) Ethernet Smart Switch Hardware Installation Guide
2. Press the Reset/Factory Defaults button for more than 5 seconds but less than
10 seconds.
CAUTION:
Do not press the button for more than 10 seconds or the device
registration flag will be erased from the switch and you will need to enter a registration
key or log into your MyNETGEAR.com account and manually enter your device
registration information.
During the reset process, the Power LED lights blinking green.
Reset the switch to factory default settings and erase the
registration status
Use this procedure to erase all settings, reset the switch to factory defaults, and erase
the registration flag from the switch. After the switch is reset, you will need to enter a
registration key or log in to your MyNETGEAR.com account, and then go through the
initial login and setup process again.
Note: We recommend that you export and save the configuration file before you press
the Reset/Factory Defaults button to reset the switch.
To use the Reset/Factory Defaults button to reset the switch to factory default settings
and erase the registration status:
1. Insert a tool such as a straightened paper clip into the opening.
2. Press the Reset/Factory Defaults button for more than 10 seconds.
CAUTION:
After the switch is reset, you will need to enter a registration key or log
in to your MyNETGEAR.com account and manually enter your device registration
information, and then go through the initial login and setup process again.
During the restart or reset process, the Power LED lights blinking green.
Hardware Overview
16
Hardware Installation Guide
Advertisement
Table of Contents
