Panasonic FP-XH Series User Manual page 120

10.5 List of Special Relays (COM Communication)
Relay No.
R904C to
Not used
R904F
(Note 1) R9040 to R904F changes even while a scan is in progress. To maintain compatibility with the existing
FP-X / FPsigma Control Unit, the same function is also allocated to the special internal relay indicated
in brackets.
WR905 (specification in word units)
Relay No.
MEWNET-W0
R9050
PLC link transmission error flag
R9051 to
Not used
R905F
WR906 (specification in word units)
Relay No.
R9060
R9061
R9062
MEWNET-W0
PLC link 0
R9063
transmission
assurance relay
R9064
R9065
R9066
10-16
Name
Error codes are stored in DT90125.
Name
When using MEWNET-W0
Turns ON when there is a transmission error in the PLC link.
Turns ON when there is an error in the setting for the PLC
link area.
Name
When Unit No. 1
Unit No. is normally communicating in PLC link mode: ON
1
When the unit is stopped, an error has occurred, or PLC link
is not established: OFF
When Unit No. 2
Unit No. is normally communicating in PLC link mode: ON
2
When the unit is stopped, an error has occurred, or PLC link
is not established: OFF
When Unit No. 3
Unit No. is normally communicating in PLC link mode: ON
3
When the unit is stopped, an error has occurred, or PLC link
is not established: OFF
When Unit No. 4
Unit No. is normally communicating in PLC link mode: ON
4
When the unit is stopped, an error has occurred, or PLC link
is not established: OFF
When Unit No. 5
Unit No. is normally communicating in PLC link mode: ON
5
When the unit is stopped, an error has occurred, or PLC link
is not established: OFF
When Unit No. 6
Unit No. is normally communicating in PLC link mode: ON
6
When the unit is stopped, an error has occurred, or PLC link
is not established: OFF
When Unit No. 7
Unit No. is normally communicating in PLC link mode: ON
7
When the unit is stopped, an error has occurred, or PLC link
is not established: OFF
Description
Description
Description
WUME-FPXHCOMG-02