Preparing The Filter For Use - Frymaster MARINE E4 FPRE 17 kW Installation, Operation, Service, And Parts Manual

RE SERIES MARINE E
CHAPTER 4: FILTRATION INSTRUCTIONS
4.1 Introduction
The FootPrint Pro filtration system allows the oil in one frypot to be safely and efficiently filtered
while the other frypots in a battery remain in operation. Section 4.2 covers preparation of the filter
system. Operation of the system is covered in section 4.3.
The work center supervisor is responsible for ensuring that operators are made
aware of the inherent hazards of operating a hot oil filtering system, particularly the
aspects of oil filtration, draining and cleaning procedures.
4.2

Preparing the Filter for Use

1. Rotate the pan-locking rod to either side
until it clears the filter pan, then pull the
pan out from the cabinet. Remove the
crumb tray, hold-down ring. Remove
the used filter paper in the pan. Remove
the filter paper support screen.
all components with a solution of
detergent and hot water then dry
thoroughly.
The filter pan on the is equipped with
rollers in rails, much like a kitchen
drawer. The pan may be removed for
cleaning or to gain access to interior
components by lifting the front of the
pan to disengage the front rollers, then
pulling it forward until the rear rollers
clear the rails. The pan cover must not
be removed except for cleaning, interior
access, or to allow a shortening disposal
unit (SDU) to be positioned under the
drain.
4
ELECTRIC FRYERS
WARNING
Rotate the locking rod
to either side to allow
the pan to be pulled
out from the fryer.
Clean
FPRE217
Screen and
Filter Pan
FPRE117
Screen and
Filter Pan
4-1