Power Requirements - Frymaster MARINE E4 FPRE 17 kW Installation, Operation, Service, And Parts Manual

Hide thumbs

Table Of Contents

Table of Contents

All wiring connections for this appliance must be made in accordance with the

wiring diagram(s) furnished with the appliance.

affixed to the inside of the appliance door when installing or servicing this

equipment.

The appliance area must be kept free and clear of combustible material at all times.

Do not block the area around the base or under the fryers.

All installation and service on FRYMASTER equipment must be performed by qualified, certified,

licensed, and/or authorized installation or service personnel.

Service may be obtained by contacting a local Frymaster DEAN Factory Authorized Servicer.

In the event of a power failure, the fryer(s) will automatically shut down. If this occurs, turn the

power switch OFF. Do not attempt to start the fryer(s) until power is restored.

A clearance of 6 inches (15cm) must be provided at both sides and back adjacent to combustible

construction. A minimum of 24 inches (61cm) should be provided at the front of the equipment for

servicing and proper operation.

Connections should be made by means of an approved, flexible-metallic or rubber-covered electrical

cable and quick-disconnect plug. The fryers may be installed with "hard-wired" connections, but

use of quick-disconnect plugs will facilitate service if required. Connections are made to the fryer

power input terminal block located in the lower back of the fryer(s).

2.2