Advertisement
5
Installing the Direction Limiter
Parts needed for this procedure:
4
Direction limiter
4
Direction-limiter shim (16 gauge)
8
Direction-limiter shim (18 gauge)
4
Direction-limiter shim (26 gauge)
4
Shim (11 gauge)
8
Shim (16 gauge)
8
Shim (18 gauge)
8
Shim (26 gauge)
4
Threaded rod
12
Hex-head bolt (12 x 130 mm)
8
Jam nut (16 mm)
8
Flat washer (16 mm)
12
Locknut (16 mm)
24
Flat washer (12 mm)
12
Locknut (12 mm)
Procedure
1. Install the direction limiter using the hardware and
shims as shown in
Note: Use the shims as required to ensure that there
is full contact between all surfaces before torquing the
fasteners. Remove any paint from the inside surfaces of
the frame-mount bracket that contact the shims. You
may need to remove material from the shim(s) to fill
any gaps around the frame-mount bracket.
Figure
11.
1
2
3
4
5
6
9
10
11
10
1. Shims (11, 16, 18, and 26
gauge; use as needed)
2. Direction-limiter shim (16
gauge)
3. Direction-limiter shims (26
gauge)
4. Direction-limiter shim (18
gauge)
5. Locknut (16 mm)
6. Flat washer (16 mm)
7. Threaded rod
2. Torque the bolts (12 x 130 mm) to 85 to 105 N∙m (60
to 75 ft-lb).
9
g037960
7
5
8
12
Figure 11
8. Jam nut (16 mm)
9. Locknut (12 mm)
10. Flat washer—12 mm (6)
11. Direction limiter
12. Bolt—12 x 130 mm (3)
13. Direction-limiter assembly
(detail)
Advertisement
