Hisense CM4340DBG User Manual page 31

MAINTENANCE
A
B
S
M
• The two red buttons are correctly snapped out (A).
• The two red buttons are not snapped out (B).
8. Replace the drip tray and waste coffee container.
9. Close the service door.
Notes
• If the brewing unit is not put in place correctly, the service door
cannot be closed.
• If it is difficult to insert the brewing unit, it must be made into the
right height (before inserting) by pressing the brewing unit firmly
together from top and bottom.
• If it is still difficult to insert the brewing unit:
• Leave it out of the appliance, place the drip tray, close the
service door, switch the main switch on the back of the
appliance to 'off' and then to 'on' again.
• Wait for all the lights to go off, then open the door, remove the
drip tray and replace the brewing unit.
• Replace the drip tray, together with the grounds container.
• Close the service door.
Cleaning the milk container (N)
Always clean the tubes inside the milk container when you prepare
milk. If there is still milk in the container, do not leave it out of the
refrigerator for longer than strictly necessary. Clean the container
each time you prepare milk as described in the section "Making
cappuccino".
All components can be washed in a dishwasher, placing them in
the top basket of the dishwasher.
1. Turn the milk container lid clockwise then remove it.
2. Remove the milk spout (S) and intake tube (M).
3. Remove the frothed milk regulator (F) by pulling it outwards.
4. Wash all the components thoroughly with hot water and mild
EN 31