Hisense CM4340DBG User Manual page 25

SETTINGS
4
continues to display the descale message and the program must be
started again from the beginning.
Failure to descale the appliance invalidates the guarantee.
Rinsing
If 2/3 minutes have passed, since you last made coffee, you should
first rinse the system to preheat the brewing unit. Select the rinsing
function from the appropriate menu. Let the water run into the drip tray
underneath. You can also use this water to warm up the cup that you
are using for the coffee. In this case simply let the hot water run into the
cup (and then empty it).
1. Press the touch key 'RINSE' (4).
2. The appliance performs an automatic rinse cycle (a little hot water
runs out of the spouts and is collected in the drip tray beneath).
Statistics
You can look up the following information values:
• total number of coffees made with the appliance up to that point;
• number of descaling procedures carried out;
• number of cappuccinos made.
• Numbers of liters of water.
2 cups of coffee dispensed at the same time are counted as 2 cups.
Proceed as follows to look up the values:
1. Press the touch key 'MENU' (2) and press the scroll touch keys (5
and 7) until the menu option "STATISTICS" appears. Confirm the
menu option with the touch key 'OK' (9).
2. The number of cups dispensed so far appears on the display, e.g.
"TOT. COFFEES 135".
3. Repeatedly press the scroll touch key (7) to show the number
of descaling procedures carried out, e.g. "TOT. DESCALES 5",
"TOTAL WATER" and then number of cappuccino's, e.g. "TOT.
CAPPUCCINO 135".
Resetting the appliance to factory settings
This function resets previously changed values to the factory settings.
EN 25