Hisense CM4340DBG User Manual page 16

USE
EN 16
4. After using the machine with pre-ground coffee, to go back to
making coffee using beans, deactivate the pre-ground coffee
function by pressing the 'Coffee strength' touch key (6).
Notes
• Never introduce pre-ground coffee when the machine is off or it
could spread through the inside of the appliance.
• Never add more than 1 measure, otherwise the appliance will not
make the coffee.
• Use the measure provided only.
• Introduce only pre-ground coffee for espresso coffee machines into
the funnel.
• If more than one measure of pre-ground coffee is used and the
funnel clogs, push the coffee down with a knife then remove and
clean the brewing unit and machine as described in the "Cleaning
the brewing unit" section.
Preparing hot water
Hot water can be used to warm up cups and to make hot drinks, such
as tea or packet soups.
Warning! Escaping hot water can lead to scalds! Only activate the
hot water nozzle when there is a receptacle underneath it.
1. Put the hot water nozzle in place.
2. Place a container underneath the hot water nozzle.
3. Press the 'Hot water' touch key (13).
The display shows "HOT WATER PRESS OK".
4. Press the touch key 'OK' (9).
Hot water is dispensed; the display shows "HOT WATER".
Once the programmed amount of hot water is dispensed,
dispensing stops automatically.
For a few seconds the display shows "PLEASE WAIT". After that the
appliance is ready to make coffee again and the last selected coffee
setting appears on the display.
Changing the quantity of hot water
The machine is set by default to automatically delivery 150 ml of hot
water. To change these quantities, proceed as follows:
1. Place a container underneath the water spout.
2. Press the touch key 'MENU'(2) to enter the menu