Hisense CM4340DBG User Manual page 13

USE
• To turn the appliance off, press the 'On-off' button (Aa / see page 5).
Before going off, the appliance performs an automatic rinse cycle.
Take care to avoid scalds.
• If the coffee only comes out in drips or not at all, the knob for setting
the grind level must be turned by one position clockwise (see
"Setting the grind level" ). Turn one click at a time until the coffee is
delivered satisfactorily.
• If the coffee comes out too fast and the cream does not meet your
taste, turn the knob by one position anti-clockwise). Make sure that
you do not turn the knob for setting the grind level too far, as coffee
may come out in drips when dispensing 2 cups.
Tips to make hotter coffee
• After 3 minutes since you last made coffee, you can preheat the
brewing unit by using the menu setting "RINSING (see Rinsing).
Run off the water into the underlying drip tray or alternatively use
this water to fill (and then empty) the cup to be used for the coffee.
• Do not use cups that are too thick, as they will absorb too much
heat.
• You can stop the coffee from dispensing by pressing the 'One cup
of coffee deliver' touch key 910) or 'Two cup of coffee deliver' touch
key (11) again, or by selecting "ESPRESSO CUP" with the 'Type/
quantity of coffee' touch key (8).
• After the coffee has finished dispensing (the progress bar reaches
100%), you can increase the amount of coffee by pressing and
holding the 'One cup of coffee' touch key until the desired amount
of coffee is reached.
• When the display shows the message "FILL TANK!", you must fill
the tank, otherwise the appliance cannot make any coffee.
It is normal that there is some water left in the water tank when the
message is displayed.
• Every 14 single coffees (or 7 doubles) the appliance displays
"EMPTY WASTE COFFEE CONTAINER". This means that the waste
coffee container is full and must be emptied and cleaned.
• The appliance counts the number of coffees made. As long as the
waste coffee container is not cleaned, this message remains in
EN 13