Fan Detection Select; Chassis/Overheat Fan Select; Watch Dog - Supermicro X5DL8-GG User Manual

SpeakerEnable/Disable
(X5DLR-8G2+, X5DLR-8G2)
To disable the onboard speaker,
remove the jumper from JP2 (see
the table on the right).

Fan Detection Select

JP58 allows you to select which fan
speed to have displayed in the
Hardware Monitors section of BIOS
(the CPU1/2 fans or the CPU1/CPU2
Chassis fans). The default position
is open to select the CPU1/2 fans.
See the table on the right for jumper
settings.

Chassis/Overheat Fan Select

JP48 allows you to select to use ei-
ther the chassis fan or the overheat
fan. The default position is closed to
select the chassis fan. See the table
on the right for jumper settings.

Watch Dog

JP3 controls the Watch Dog function.
Watch Dog is a system monitor that
takes action when a software appli-
cation freezes the system.
will have WD reset the system if a
program freezes. Pins 2-3 will gener-
ate a non-maskable interrupt for the
program that has frozen (requires
software implementation).
table on the right for jumper settings.
Watch Dog must also be enabled in
BIOS.
Pins 1-2
See the
2-17
Chapter 2: Installation
Speaker Enable/Disable
Jumper Settings
(JP2)
Jumper
Position Definition
Closed Enabled
Open Disabled
Fan Detection Select
Jumper Settings (JP58)
Jumper
Position Definition
Open CPU1/2 Fans
Closed CPU1/2 Ch Fans
Chassis/Overheat Fan
Select Jumper Settings
(JP48)
Jumper
Position Definition
Open Overheat Fan
Closed Chassis Fan
W atch Dog
Jumper Settings (JP3)
Jumper
Position Definition
Pins 1-2 W D to Reset
Pins 2-3 W D to NMI
Open Disabled