Table of Contents
Advertisement
2.
Installing/removing hot-swap SCSI drives
The SCSI drive bays are located in the front of the chassis, making them
easily accessible for installation and removal. The SCSI drives are hot-swap
units, meaning that they can be installed and removed while the system is
running. To remove a SCSI drive, first push the colored release button
located beside the drive's LEDs, then swing the handle fully out and use it to
pull the SCSI drive carrier straight out (see Figure 6-5).
Important:
!
the drive bays to maintain proper cooling airflow.
Figure 6-5. Removing SCSI Drives
All of the SCSI drive carriers must remain in
6-7
Chapter 6: Advanced Chassis Setup
Advertisement
Table of Contents
