Table of Contents
Advertisement
Figure 5-1.
604-pin PGA Socket: Empty and with Processor Installed
Warning!
installing the CPU. If the lever is only partly raised, damage
!
to the socket or CPU may result.
Empty socket
Lever
Triangle (pin 1)
Heatsink Installation*
1. Do not apply any thermal compound to the heatsink or the CPU die; the
required amount has already been applied.
2. Place the heatsink on top of the CPU so that the four mounting holes are
aligned with those on the retention mechanism.
3. Screw in two diagonal screws until snug (do not fully tighten the screws
to avoid possible damage to the CPU). The screw in the other two diagonal
screws until snug.
4. Finish the installation by fully tightening all four screws.
Note: refer to page 7-18 for a BIOS setting that determines fan speed.
*The passive 1U heatsink (p/n SNK-P009) to be used with the 6014A-8 is an
optional item that is sold separately.
Chapter 5: Advanced Serverboard Setup
Make sure you lift the lever completely when
(Refer to Figure 5-2.)
5-3
With processor installed
Triangle locating pin 1
Advertisement
Table of Contents
