Table of Contents
Advertisement
S
S
UPER
ERVER 6014A-8 Manual
6. Press Enter.
7. Read the warning message as shown on the screen below.
8. Make sure that you have selected the correct disk drives to initialize.
If correct, type Y to continue.
Rebuilding Arrays
Note 1: Rebuilding applies to Fault Tolerant arrays (RAID 1) only.
If an array build process (or initialization) is interrupted or critical with
one member missing, you must perform a rebuild to optimized its function-
ality. For a critical array rebuild operation, the optimal drive is the source
drive.
Note 2: If no spare array exists and a hard disk drive fails, you need to
create a spare before you can rebuild an array.
To Rebuild an array:
1. From the Main Menu, select Manage Arrays. From the list of arrays,
select the array you want to rebuild.
2. Press Ctrl+R to rebuild.
C-14
Advertisement
Table of Contents
