Bluetooth Pairing - Monoprice DT-4BT User Manual

3. Connect one end of the included Speaker Interconnect Cable to the Speaker
Input Connector on the rear panel of the Slave Speaker, then connect the other
end to the Speaker Output Connector on the rear panel of the Master Speaker.
4. (Optional) Plug one end of the included 3.5mm Stereo Audio Cable into the
3.5mm AUX Input on the front panel of the Master Speaker, then plug the other
end into the output of your audio source device.
5. (Optional) Plug one end of the included Stereo RCA Audio Cable into the Stereo
RCA Input on the rear panel of the Master Speaker, then plug the other end into
the output of your audio source device.
6. (Optional) Plug one end of a 1/4" TRS or TS audio cable (not included) into the
left channel Stereo 1/4" TRS Balanced Input on the rear panel of the Master
Speaker, then plug the other end into the left channel output of your audio
source device. Repeat for the right channel.
7. Plug the AC Power Cord into a nearby AC power outlet.
Note that the output of the speakers is the sum of all inputs. Unless you specifically
want to listen to a mix of different sources, only one audio input should be in active use
at a time.

BLUETOOTH PAIRING

Perform the following steps to pair your mobile device with the speakers.
1. Flip the Power Switch on the rear panel of the Master Speaker to the ON
position. The LED Power Indicator on the front panel will illuminate.
2. Momentarily press and release the Bluetooth Pairing Button on the rear panel of
the Master Speaker. The LED Bluetooth Indicator on the front panel will begin
flashing, indicating that the speaker is in Bluetooth pairing mode.
3. Open the Bluetooth settings on your mobile device, then scan for nearby
Bluetooth devices.
6