Table of Contents
Advertisement
CHARGING
Charge the battery before first use and at least once every three months to keep it fresh and capable
of holding the full charge. Perform the following steps to charge the battery in the speaker.
1.
The speaker will emit a beep every few seconds when the battery is low and needs charging.
2. Plug one end of the included USB Type-C® Charging Cable into the USB-C® Charging Port on
the speaker, then plug the other end into a USB power source, such as a computer, wall
charger, or power bank (available separately). The LED Indicator illuminates red while charging
is in progress. It will take about 4 hours to fully charge the battery.
3. When the LED Indicator turns off, the battery is fully charged. Unplug the USB Type-C Charging
Cable from the USB power source, then unplug it from the speaker. Store it in a safe place for
future use.
BLUETOOTH PAIRING
Perform the following steps to pair your device with the speaker. Note that the speaker cannot enter
Bluetooth® mode if an audio cable is plugged into the 3.5mm Audio Jack.
1.
With the speaker powered off, press and hold the Power Button for 2 seconds to turn the
speaker on. The LED Indicator will begin flashing blue and you will hear a tone, indicating that
the speaker is in Bluetooth pairing mode.
Note that if a device has already been paired, is powered on, and is within range, the speaker
will reconnect with that device automatically. To pair the speaker with another device, delete
5
Advertisement
Table of Contents
