Table of Contents
Advertisement
There may still be residual water in the
reservoir. The amount will depend on
the water hardness level and the
amount of limescale present.
One reservoir is sufficient for approx.
40 minutes of ironing with steam. It
takes approx. 4 minutes for the water to
heat up to the correct temperature for
steam ironing. The heating-up time may
change as a result of limescale building
up in the reservoir.
^ It is advisable to switch off the steam
function during an interruption to
ironing and at the end of ironing.
Emptying the water reservoir
,
Before emptying the reservoir
make sure that the water in it has
cooled down and that the heater
plate has cooled down.
The reservoir should be emptied after
each use to avoid damage from
deposits present in the water (e.g.
chlorine, calcium or copper).
^ Unscrew the water reservoir cap.
^ To make it easier, use the screw-on
funnel.
^ Slowly fold the ironer up and at the
same time hold a suitable container
(e.g. a measuring jug) underneath
the reservoir to catch the water.
^ When all the water has run out,
replace the cap.
^ The screw-on funnel can be stored
on the cable holder when not in use.
Steam
17
Advertisement
Table of Contents
