Sharp XG-E690UB Operation Manual page 10

Connecting the Projector (RGB: Computer)
1
INPUT
COMPUTER
RGB
IBM-PC (VGA,
ANALOG RGB OUT
SVGA) Series
(computer)
RGB Signal
Output Socket
Mac/VGA Adaptor (Supplied)
Q
2
Macintosh
RGB Signal
Output Socket
W
Rear view of
the projector
RGB Signal
Input Socket
Rear view of the projector
RGB Signal
OUTPUT FILTER Input Socket
OFF ON
VGA Signal
Cable
(Supplied)
Macintosh
RGB Signal Output Socket
ANALOG
RGB OUT
VGA Signal
Cable
(Supplied)
You can connect your projector to a computer for easy
projection of full-color computer images, or an external
monitor for simultaneous viewing.
Before connecting, be sure to turn both the projector and the
computer off.
After making all connections, turn the projector on first. The
computer should always be turned on last.
1. Connecting to an IBM-PC (VGA, SVGA)
Series computer—800 x 600 maximum
resolution
Plug the VGA signal cable correctly into the RGB INPUT
terminal on the projector and into the RGB signal output
terminal on the computer, and secure the plugs by tightening
the thumb screws.
Note:
• This connection is possible only when using a computer
with a VGA/SVGA or Mac display output port.
2. Connecting to a Macintosh Series
Computer
• 640 x 480 resolution
Q First, connect the supplied Mac/VGA adaptor to the RGB
signal output terminal on your Macintosh Series computer,
as shown on the left, and secure the plugs.
W Next, firmly plug the supplied VGA signal cable into both
the RGB input terminal on the projector and the Mac/VGA
adaptor on the computer, and secure the plugs by
tightening the thumb screws.
• 832 x 624 resolution
When connecting in the 832 x 624 dot mode, use a Mac/VGA
adaptor with display mode switching function available from
your local computer dealer.
E-10